Q-Logic 59048-02 A Switch User Manual


 
A – Command Line Interface
Show Command
A-58 59048-02 A
Q
The following is an example of the Show NS [domain_ID] command:
SANbox2 #> show ns 18
Seq Domain Port Port
No ID ID Type COS PortWWN NodeWWN
--- ------ ------ ---- --- ------- -------
1 18 (0x12) 120700 N 3 21:00:00:e0:8b:07:a7:bc 20:00:00:e0:8b:07:a7:bc
The following is an example of the Show NS [port_ID] command:
SANbox2 #> show ns 1301e1
Port ID: 1301e1
--------
PortType NL
PortWWN 21:00:00:20:37:73:13:69
SymbolicPortName
NodeWWN 20:00:00:20:37:73:13:69
SymbolicNodeName
NodeIPAddress 0.0.0.0
ClassOfService 3
PortIPAddress 0.0.0.0
FabricPortName 20:01:00:c0:dd:00:bc:56
FC4Type FCP
FC4Desc (NULL)
The following is an example of the Show Interface command:
SANbox2 #> show interface
eth0 Link encap:Ethernet HWaddr 00:C0:DD:00:BD:ED
inet addr:10.20.68.107 Bcast:10.20.68.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4712 errors:0 dropped:0 overruns:0 frame:0
TX packets:3000 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:415313 (405.5 Kb) TX bytes:716751 (699.9 Kb)
Interrupt:11 Base address:0xfcc0
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:304 errors:0 dropped:0 overruns:0 frame:0
TX packets:304 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:20116 (19.6 Kb) TX bytes:20116 (19.6 Kb)