Filter
Top Products
A – Command Line Interface
Set Setup Command
59048-02 A A-47
Q
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table A-14 describes the system configuration fields. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
TrapCommunity Trap community password that authorizes an SNMP agent to
receive traps. This is a write-only field. The value on the switch
and the SNMP management server must be the same. The
default is “public”.
AuthFailureTrap Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is False.
ProxyEnabled Enables (True) or disables (False) SNMP communication with
other switches in the fabric. The default is True.
Note: Changing the IP address will terminate all Ethernet management
sessions.
Table A-14. System Configuration Settings
Entry Description
Eth0NetworkDiscovery Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
4 - RARP. The default is 1 - Static.
Eth0NetworkAddress Ethernet Internet Protocol (IP) address. The default is
10.0.0.1.
Eth0NetworkMask Ethernet subnet mask address.
Eth0GatewayAddress Ethernet IP address gateway.
FCNetworkDiscovery Fibre Channel boot method: 1 - Static, 3 - DHCP. The
default is 1 - Static.
FCNetworkAddress Fibre Channel Internet Protocol (IP) address for the
Ethernet port. The default is 0.0.0.0.
FCNetworkMask Fibre Channel subnet mask address. The default is
255.0.0.0.
FCGatewayAddress Fibre Channel IP address gateway. The default is
10.0.0.254.
Table A-13. SNMP Configuration Settings (Continued)
Entry Description