Filter
Top Products
10-12 SANRAD V-Switch CLI User Manual
-ip
IP ADDRESS IP ADDRESS
ASSIGNING TO THE
INTERFACE PORT
MANDATORY
212.199.43.57
with a different IP
address will not reset
the network port
address. It will add
another IP address to
the network port
-im
IP MASK IP NET MASK OPTIONAL
DEFAULT:
255.255.255.0
-act
ACTIVITY IF IP ADDRESS IS
ACTIVE TO EXPOSE
VOLUMES
. USE
INACTIVE STATUS
TO ALLOW
FAILOVER
.
OPTIONAL
DEFAULT: 1
(ACTIVE).
2(
INACTIVE)
1
Example:
IP address 212.199.43.57 is added to interface eth1 for a total of two IP addresses
assigned to interface eth1.
ip config set –if eth1 –ip 212.199.43.57
10225
212.199.12.67
212.199.12.70
212.199.75.66212.199.43.46
212.199.43.56
212.199.43.57
Figure 10-1. Adding an Interface IP Address
Removing an Interface IP Address
If you are working in
a V-Switch cluster,
the interface IP must
be removed on both
V-Switches.
You can remove an IP address from the network ports.
ip config remove
You need to define one parameter to remove a network port IP address:
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-ip
IP ADDRESS IP ADDRESS TO
REMOVE FROM THE
NETWORK
INTERFACE PORT
MANDATORY
212.199.12.70