Filter
Top Products
Chapter 11: Command Line Interface 11-23
Volume Configuration
These commands enable you to configure and view disks and volumes via the
V Switch.
COMMAND COMMAND COMMAND COMMAND
STORAGE DISCOVERY SUBDISK DETAILS VOLUME CREATE
STRIPED
VOLUME MIRROR BREAK
STORAGE BLINK
ACTIVATE
SUBDISK ALIAS VOLUME SET VOLUME RESIZE
STORAGE BLINK ABORT SUBDISK SET VOLUME REMOVE VOLUME RETRACT
STORAGE SHOW SUBDISK REMOVE VOLUME REMOVE -ALL VOLUME EXPAND
STORAGE DISK SHOW VOLUME SHOW VOLUME REPLACE VOLUME CREATE
SNAPSHOT
STORAGE DISK SET VOLUME DETAILS VOLUME MIRROR SYNC
SHOW
VOLUME SNAPSHOT
SHOW
STORAGE ALIAS VOLUME ALIAS VOLUME MIRROR SYNC
START
VOLUME SNAPSHOT LIST
STORAGE DETAILS VOLUME HIERARCHY VOLUME MIRROR SYNC
ABORT
VOLUME SNAPSHOT
ROLLBACK SHOW
STORAGE SET VOLUME CREATE SIMPLE VOLUME COPY CREATE VOLUME SNAPSHOT
ROLLBACK START
STORAGE REMOVE VOLUME CREATE
TRANSPARENT
VOLUME COPY SHOW VOLUME SNAPSHOT
ROLLBACK ABORT
SUBDISK CREATE VOLUME CREATE
MIRROR
VOLUME COPY ABORT
SUBDISK SHOW VOLUME CREATE
CONCATENATED
VOLUME MIRROR ADD
storage discovery
This command resets the Fiber Channel loop and reregisters all attached
storage devices. In most cases, the V-Switch automatically discovers new
storage. Use this command after adding or removing storage devices from the
V Switch topography if it is not automatically discovered. Because this
command resets the FC loop, it may cause a failure of any I/O operations being
executed when the command is invoked.
storage discovery