Filter
Top Products
4-14 SANRAD V-Switch CLI User Manual
Example
fc set –if fc2 –sp 1 –pt nl –cm prl
Viewing the V-Switch World Wide Node Name
Use the CLI command fc node show to view the V-Switch World Wide Node
Name (WWNN).
fc node show
Name V-Switch1
Description SW Version 1.5, build 5,patch 0
Board version 1, PCB version
WWNN 20:00:20:10:58:00:10:46
Function Gateway
Configuring the Network Ports
Each network port
must be located on a
separate subnet.
Each network port
can have more than
one IP address.
To connect the V-Switch to the network you need to assign IP parameters
to each 1Gb Ethernet network port connected to a network. Each network
port must be located on a separate subnet. Each network port can have
more than one IP address. Use the CLI command ip config set to
assign IP parameters. Once configured, each network port will provide an
access point for hosts to the storage network. Once access is gained, a host
will be able to read from and/or write into the storage network.
ip config set
You need to define three parameters to configure each network port:
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-ip
IP ADDRESS IP ADDRESS
ASSIGNING TO THE
INTERFACE PORT
MANDATORY
212.199.43.56
-if
INTERFACE ALIAS
OR NAME
NETWORK
INTERFACE PORT
MANDATORY
ETH1, ETH2,
ETH
3
eth1
Executing this
command on the
same network port
with a different IP
address will not reset
the network port
address. It will add
another IP address to
the network port
-im
IP MASK IP NET MASK OPTIONAL
DEFAULT:
255.255.255.0