Filter
Top Products
Chapter 4: V-Switch Configuration 4-5
RS232 Serial Connection
To initialize the V-Switch via an RS-232 serial connection:
Connect the cable to the appropriate port on the management server,
and open a Terminal session. Set the following parameters in the
terminal:
PARAMETER SYSTEM REQUIREMENT
CONFIG SERIAL PORT COMX (ACCORDING TO YOUR PHYSICAL PORT CONNECTION)
BITS PER SECOND 115200
D
ATA BITS 8
P
ARITY NONE
S
TOP BITS 1
F
LOW CONTROL NONE
E
MULATION AUTODETECT
Figure 4-2. Terminal Properties