Filter
Top Products
A-30 SANRAD V-Switch User Manual
Now, use the CLI command ip config set to configure the IP
takeover address for Eth 1. This IP address will be the IP address of Eth 1
on VSwitch2. The address will sit inactive (2) unless VSwitch2 goes offline.
Then VSwitch1 will activate (1) this address and direct all read/write
commands to this address through Eth1 on VSwitch1.
ip config set –if eth1 -ip 212.199.43.75 –im
255.255.255.0 –act 2
STEP 12. C
ONFIGURE V-SWITCH 1 ISCSI PORTALS
The port number you
set in the CLI must
coincide with the port
number you set in
your iSCSI initiator
configuration.
Use the CLI command iscsi portal create to configure the iSCSI portal
on network port Eth 2 for iSCSI communications between VSwitch1 and the host
stations.
iscsi portal create –ip 212.199.43.56 –p 5003
Use the CLI command again to configure the iSCSI portal for the inactive IP
address on Eth 2 to allow iSCSI communications via this IP on VSwitch1 in
the event of VSwitch2 failover.
iscsi portal create –ip 212.199.43.75 –p 5003
STEP 13. C
ONFIGURE V-SWITCH 2 NETWORK PORT ETH 1 IP ADDRESSES
Use the CLI command ip config set to configure the network port
Eth 1 for communications between VSwitch2 and the host stations on
VSwitch2. Set the IP address as active (1) to allow read/write commands
to pass through this IP address.
ip config set –if eth1 -ip 212.199.43.75 –im
255.255.255.0 –act 1
Now, use the CLI command ip config set to configure the IP
takeover address for Eth 1. This IP address will be the IP address of Eth 1
on VSwitch1. The address will sit inactive (2) unless V-Switch 1 goes offline.
Then VSwitch2 will activate (1) this address and direct all read/write
commands to this address through Eth 1 on VSwitch2.
ip config set –if eth1 -ip 212.199.43.56 –im
255.255.255.0 –act 2