Filter
Top Products
Appendix: Sample Configurations A-19
STEP 5. LOGIN TO THE MANAGEMENT PORT
From your management terminal, open a Telnet session with the
management port.
From the Windows Start menu, select Run.
In the Open window, enter:
telnet 100.100.100.2
Click OK. A Telnet session window opens.
Press Enter on your keyboard to open the V-Switch 3000 Login window.
Figure A-10. V-Switch 3000 Login Screen
Enter the default user name and password and press Enter on your
keyboard. The CLI prompt > appears. You are now logged in and ready to
begin configuring your V-Switch for volume virtualization and exposure.
STEP 6. CONFIGURE NETWORK PORT ETH 2 IP ADDRESS
Use the CLI command ip config set to configure the network port
Eth 2 for communications between the V-Switch and host stations.
ip config set –if eth2 –ip 212.199.43.56 –im
255.255.255.0 –act 1
STEP 7. C
ONFIGURE ISCSI PORTAL
The port number you
set in the CLI must
coincide with the port
number you set in
your iSCSI initiator
configuration.
Use the CLI command iscsi portal create to configure the iSCSI portal
on network port Eth 1 for iSCSI communications between the V-Switch and the
host station.
iscsi portal create –ip 212.199.43.56 –p 5003