Filter
Top Products
4-16 SANRAD V-Switch CLI User Manual
10225
212.199.12.67
212.199.12.70
212.199.75.66212.199.43.46
212.199.43.56
212.199.43.57
Figure 4-4. V-Switch IP Adresses
Removing an IP Address
An IP address that
has a portal
configured on it
cannot be removed.
Network ports can have multiple IP addresses. You can remove an IP
address that is no longer relevant from a network port using the CLI
command ip config remove. You can remove the last network IP
address from a port, but you cannot remove the management IP address
from Eth1. If you are working in a cluster, the IP address must be
removed from both V-Switch databases. For more information on V-
Switch clusters, see “Introduction to V-Switch Clusters”.
ip config remove
You need to define one parameter to remove a network port IP address:
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-ip
IP ADDRESS IP ADDRESS TO
REMOVE FROM THE
NETWORK
INTERFACE PORT
MANDATORY
212.199.12.70
Example:
The IP address 212.199.12.70 is removed from Eth3 leaving the port with only
one IP address, 212.199.12.67.
ip config remove –ip 212.199.12.70