Filter
Top Products
Chapter 4: V-Switch Configuration 4-15
SWITCH PARAMETER DEFINITION STATUS EXAMPLE
-act
ACTIVITY IF IP ADDRESS IS
ACTIVE TO EXPOSE
VOLUMES
. USE
INACTIVE STATUS
TO ALLOW
FAILOVER
.
O
PTIONAL
D
EFAULT: 1
(ACTIVE)
2
(INACTIVE)
1
For regular port activity, use the default active port setting. The inactive port
setting is used when configuring a V-Switch cluster. If you are configuring a V-
Switch cluster, each IP address must be configured on both V-Switches in the V-
Switch cluster. For more information on V-Switch clusters, see “Introduction to
V-Switch Clusters”.
Example:
The IP address 212.199.43.56 is assigned to the 1 Gb Ethernet port Eth1.
ip config set –ip 212.199.43.56 –if eth1 –act 1
10224
212.199.43.56
Figure 4-3. Ethernet Port 1 IP Address
Checking the IP Configurations
After setting the management and network port IP addresses, you can use the
CLI command ip config show to access the IP Configuration Table and
view all assigned port IP addresses.
ip config show
Table 4-3: V-Switch IP Configuration Table
If Name IP Address Net Mask Activity
mgmt 212.199.43.46 255.255.255.0 Active
eth1 212.199.43.56 255.255.255.0 Active
eth1 212.199.43.57 255.255.255.0 Inactive
eth2 212.199.75.66 255.255.255.0 Active
eth3 212.199.12.67 255.255.255.0 Inactive
eth3 212.199.12.70 255.255.255.0 Active