Filter
Top Products
A-4 SANRAD V-Switch User Manual
STEP 2. POWER UP STORAGE DEVICE
Power up the JBOD appliance first to allow the V-Switch to register it in its
network scan.
STEP 3. POWER UP V-SWITCH
Connect the power cord to the V-Switch and then to the electric socket.
Turn the V-Switch on. The V-Switch powers up. The fan assembly is
running and the LCD panel displays:
V-Switch 3000
Status: OK
STEP 4. C
ONFIGURE CONSOLE
You are using your PC as both the V-Switch’s management station and the
network host station.
Before you can open a CLI session via the RS232 connection, your console
must be configured to allow communication between the two devices.
Open your terminal emulation program and set the system parameters as
follows:
Table A-1: Console Configuration Parameters
PARAMETER SYSTEM REQUIREMENT
CONFIG SERIAL PORT COM
BITS PER SECOND 115200
D
ATA BITS 8
P
ARITY NONE
S
TOP BITS 1
F
LOW CONTROL NONE
STEP 5. LOGIN TO THE MANAGEMENT PORT
From the open terminal emulation window, press Enter on your keyboard
to open the V-Switch 3000 Login window.