Filter
Top Products
2-44
Section 2 — Startup & Configuration
NOTE:
Increasing the EFF SEND DELAY any further will not change
the Effects Send appearance. It will, however, delay the entry into Effects
Send unnecessarily.
Mapping DPM Aux Buses
Set up the aux bus-to-device assignment as follows:
1. From the DPM Setup Menu, press DPM MAP AUX BUSES> to
access the DPM Map Aux Buses Menu.
2. Press the DEVICE SELECT button to select the desired DEVICE
(1 through 4).
3. For Kaleidoscope, rotate the NUMBER OF CHANNELS knob to
assign Aux Buses 1 through n to this DPM number. Turn the
FIRST CHANNEL knob to assign the first aux bus to the first
physical channel of the DPM.
DPM MAP AUX BUSES MENU
DEVICE
SELECT
DPM 1
AUX 5
CHAN A
-
-
-
AUX 6
CHAN B
-
-
-
MISC
PHYS CHAN
DPM 2
DPM 3
DPM 4
NUMBER OF CHANNELS
= 4
FIRST CHANNEL
= CHAN E
-
CHAN D
-
-
-
-
CHAN F
-
-
-
-
CHAN G
-
-
-
-
CHAN H
-
-
-
-
CHAN E
-
-
-
AUX 7
CHAN C
-
-
-
config / extern if / dpm setup / dpm map aux buses
DPM 1 - - - - AUX3 AUX 4AUX 2AUX 1
Connection of physical AUX buses
to physical channels