Filter
Top Products
3 and Diagnostics 3.27 SETUP
Boot Priority =HDD→FDD→CD-ROM→LAN
HDD Priority =Built-in HDD
→
PC Card
Network Boot Protocol = PXE
Total = XXXXX KB
(*1)
MEMORY
Not Registered
Power On Display = Auto-Selected
TV Type = NTSC(Japan)
Power-up mode = Boot
CPU Cache = Enabled
Level 2 Cache = Enabled
Dynamic CPU Frequency Mode
(*2)
= Dynamically Switchable
Auto Power On = Disabled
Panel Power On/Off = Disabled
(*3)
SYSTEM SETUP (1/2) ACPI BIOS version = X.X
X
BOOT PRIORITY
PASSWORD
DISPLAY
Battery Save Mode = Full Power
BATTERY
Others
↑↓→←: Select items Space, BkSp: Change values PgDn, PgUp: Change pages
Esc: Exit without saving Home : Set default values End: Save changes and Exit
Date(MM-DD-YY) = XX-XX-XXXX
Time(HH:MM:SS) = XX:XX:XX
SYSTEM DATE/TIME
Controller Mode = Auto-Selected
Device Config. = Setup by OS
CONFIGURATION
Parallel = LPT1(378H/IRQ7/CH3)
PCI BUS = IRQ10, IRQ11
Built-in HDD = Primary IDE(1F0H/IRQ14)
CD-ROM = Secondary IDE(170H/IRQ15)
SYSTEM SETUP (2/2) ACPI BIOS version = X.XX
PC CAR
D
I/O PORT
S
DRIVERS I/
O
PCI BU
S
↑↓→←
: Select items Space, BkSp: Change values PgDn, PgUp: Change pages
Esc: Exit without saving Home : Set default values End: Save changes and Exit
Built-in LAN = Enable
d
PCI LAN
USB KB/Mouse Legacy Emulation
= Enabled
USB FDD Legacy Emulation = Enabled
LEGACY EMULATION
Internal Pointing Device = Enabled
Parallel Port Mode = ECP
Hard Disk Mode = Enhanced IDE(Normal)
PERIPHERA
L
NOTE: 1. (*1) This depends on model.
2. (*2) This is displayed only for Intel Pentium4-M processor model.
3. (*3) This is displayed only in the resume mode.
3-70 Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)