Filter
Top Products
4 Replacement Procedures 4.18 Fluorescent Lamp
4
4.18 Fluorescent Lamp
This system uses LCD modules from the following suppliers. The procedure for replacing the
fluorescent lamp is different for each LCD module. Refer to the appropriate procedure.
Type Part No. Supplier Section
14.1 inch
G33C00012110 TMD 4.18.1
(XGA)
G33C00013110 TMD
4.18.1
VF2093P01 CHIMEI
4.18.2
VF2058P01 Samsung
4.18.3
VF2048P01 Samsung
4.18.4
VF2062P01 LG.Philips 4.18.5
15.0 inch
G33C0000G110 LG.Philips
4.18.6
(XGA)
G33C0000L110 Samsung
4.18.7
G33C0000Q110 Sharp
4.18.8
G33C0000M110 CHIMEI 4.18.9
15.0 inch
G33C0000R110 LG.Philips 4.18.10
(SXGA+)
G33C0000N110 Samsung
4.18.11
G33C0000P110 Sharp 4.18.12
NOTE: - When working with a LCD module, always use a flat, grounded table.
(1) Handle the backlight unit in the environment without dust, such as on the clean
bench. Keep the worktable free from any screws or other material that may scratch
the LCD surface.
(2) Use an anti-static or protective sheet.
(3) When replacing the FL unit, cover with a finger protector or similar to prevent
dirtying or scratching the LCD panel.
(4) Take care when handling the lamp. Excessive force may break the lamp.
(5) Take care not to dirty or deform the lamp reflector.
(6) Ensure always that the power of the LCD module is turned off before connecting or
disconnecting cables and connectors.
4-64 Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)