Filter
Top Products
4 Replacement Procedures 4.10 Display Assembly
Installing the Display Assembly
The following describes the procedure for installing the display assembly (See Figure 4-24 to
4-26).
1. Close the display and install the display assembly on the base assembly from the rear
of the computer.
2. (For wireless LAN models only)
Pass the wireless LAN cables through the slot and hook the cables on the guides.
3. Secure the following screws to fix the bottom and rear of the computer.
• M2.5x5 THIN BIND screw x7
• M2.5x16 THIN BIND screw x13
4. Turn the computer face up and open the display.
5. Turn up the insulator covering the speaker connectors and connect the speaker cables
(Blue, Red) to PJ6000 and PJ6001 on the system board respectively. Insert the
insulator inside the chassis.
6. Connect the LCD cable to PJ5600 on the system board.
4-38 Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)