Filter
Top Products
4 Replacement Procedures 4.9 Optical Drive
4
4.9 Optical Drive
This section describes how to remove and install a CD-ROM drive as an example. The
procedure for a DVD-ROM, Combo, Combo+2 or DVD-Multi drive is the same.
NOTE: Do not apply excessive force to the top of an optical drive.
Removing the Optical Drive
The following describes the procedure for removing the Optical drive (See Figure 4-22, 4-23).
1. Turn the computer face down and remove the following screw securing the CD-ROM
drive.
• M2.5x5 THIN BIND screw x1
2. Turn the computer face up and open the display. Press the CD-ROM drive assembly
towards the direction indicated by the arrow and disconnect the CD-ROM drive
assembly from the PJ1800 on the system board.
M2.5x5 THIN BIND
Optical Drive
(CD-ROM Drive)
Figure 4-22 Removing CD-ROM Drive (1)
4-32 Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)