Filter
Top Products
4.16 LCD Unit/FL Inverter 4 Replacement Procedures
3. Peel off the mask tapes from the sides of the display and remove the following screws
fixing the LCD unit.
• M2x4 SUPER THIN BIND screw x4
4. With the bottom edge of the LCD unit resting on the display cover, lift the top edge of
the LCD unit. Peel off the glass tape and disconnect the LCD cable from the
connector on the back of the LCD.
5. Remove the following screw fixing the FL inverter.
• M2x4 SUPER THIN BIND screw x1
6. Remove the insulator and disconnect the two cables from the connectors CN1 and
CN2 on the FL inverter and remove the FL inverter.
7. Remove the LCD unit from the display cover.
M2x4 SUPER THIN BIND
Mask Seal
M2x4 SUPER THIN BIND
Mask Seal
LCD Cable
CN2
Glass Tape
FL Inverter
M2x4 SUPER THIN BIND
Mask Seal
Mask Seal
Insulator
CN1
Figure 4-35 Removing FL Inverter and LCD Unit
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445) 4-51