Filter
Top Products
4.18 Fluorescent Lamp 4 Replacement Procedures
Installing the double-sided tape, lamp assembly, bottom cover (B), sheets, light guide,
adhesive tape, and board assembly
1. Install the lamp assembly using the double-sided tape (install the lamp housing) (1).
2. Install the lamp assembly to the mold frame and connect the low voltage cable to the
mold frame (2). Be careful not to apply excessive force to the cable.
3. Install the bottom cover (B) using the double-sided tape (for grounding) (3).
4. Install the Kapton tape to the main supporter (to protect the cable (G)) (4).
5. Install the bottom cover (B) and screws (5). The screw tightening torque is 2.0kgf.cm
maximum.
6. Install the sheets and light guide (6). Be careful not to scratch or get dirt on the sheets.
7. Fix the sheets with the adhesive tape (7).
8. Install the board assembly (8). Be careful not to apply excessive force to the TCP or
PCB.
Figure 4-86 Replacing 14.1 Inch LG.Philips fluorescent lamp (5)
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445) 4-97