Filter
Top Products
4.12 BAT CON Holder 4 Replacement Procedures
4.12 BAT CON Holder
Removing the BAT CON Holder
The following describes the procedure for removing the BAT CON holder (See Figure 4-28).
1. Remove the following screws fixing the BAT CON holder.
• M2.5x8 THIN BIND screw x2
2. Remove the BAT CON holder from the system board.
BAT CON Holder
THIN BIND M2.5x8
Figure 4-28 Removing BAT CON Holder
Installing the BAT CON Holder
The following describes the procedure for installing the BAT CON holder (See Figure 4-28).
1. Install the CON holder on the system board.
2. Secure the BAT CON holder with the following screws.
• M2.5x8 THIN BIND screw x2
Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445) 4-41