Filter
Top Products
Prestige 782R G.SHDSL Router
System Maintenance 10-13
Figure 10-16 Menu 24.7.1 – Uploading Router Firmware
10.7.2 Uploading Router Configuration File
The configuration data, system-related data, the error log and the trace log are all stored in the configuration
file. Please be aware that uploading the configuration file replaces everything contained within.
Menu 24.7.2 shows you the instructions for uploading the configuration file. If you type Y at the prompt,
the Prestige will go into debug mode. Follow the next procedure to upload the configuration file:
Step 1. Type atlc after the Enter Debug Mode message.
Step 2. Wait for the Starting Xmodem upload message before activating Xmodem upload on your
terminal.
Step 3. After successful configuration file upload, type atgo to restart the Prestige.
If you replace the current configuration file with the default configuration file, you will lose all previous
configurations and the speed of the console port will be reset to the default of 9600 bps with 8 data bit, no
parity, 1 stop bit (8n1) and no Flow Control. You will need to change your serial communications software
to the default before you can reconnect to the Prestige. The password will be reset to the default of 1234.
Menu 24.7.1 - System Maintenance - Upload System Firmware
To upload system firmware:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atur" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
XMODEM upload on your terminal.
4. After successful firmware upload, type "atgo" to restart the
system.
Warning: Proceeding with the upload will erase the current system
firmware.
Do You Wish To Proceed? (Y
/
N)