Filter
Top Products
Prestige 782R G.SHDSL Router
5-4 Remote Node TCP/IP Configuration
Figure 5-4 Menu 11.3 – Remote Node Novell IPX Options
The following table shows the fields in Menu 11.3 – Remote Node Network Layer Options.
Table 5-2 TCP/IP Remote Node Configuration
FIELD DESCRIPTION OPTIONS
Rem IP Addr This is the IP address you entered in the previous menu.
Rem Subnet Mask Type the subnet mask for the remote network.
My WAN Addr Some implementations, especially UNIX derivatives, require
separate IP network numbers for the WAN and LAN links and
each end to have a unique address within the WAN network
number. In that case, type the IP address assigned to the WAN
port of your Prestige.
NOTE: This is the address assigned to your local Prestige, not
the remote router. If the remote router is a Prestige, then this
entry determines the local Prestige Rem IP Addr in Menu 11.1.
Single User
Account
Set this field to Yes to enable the Single User Account feature
for your Prestige. Use [SPACE BAR] to choose between Yes
and No. See the Internet Access chapter for more information
on the Single User Account feature.
Yes/No
Metric Metric represents the “cost” of transmission for routing purposes.
IP routing uses hop count as the measurement of cost, with a
minimum of 1 for directly connected networks. Type a number
that approximates the cost for this link. The number need not be
precise, but it must be between 1 and 15. In practice, 2 or 3 is
usually a good number.
1 to 15
Menu 11.3 - Remote Node Network Layer Options
IP Options:
Rem IP Addr:
Rem Subnet Mask= N/A
My WAN Addr= N/A
Single User Account= N/A
Metric= N/A
Private= N/A
RIP Direction= N/A
Version= N/A
Multicast= N/A
IP Policies=
IPX Options:
Rem LAN Net #= 00000000
My WAN Net #= 00000000
Hop Count= 1
Tick Count= 2
Bridge Options:
Ethernet Addr Timeout(min)= N/A
Press ENTER to Confirm or ESC to Cancel: