Filter
Top Products
Prestige 782R G.SHDSL Router
2-8 Hardware Installation and Initial Setup
Step 2. Type your new system password (up to 30 characters) and press [ENTER].
Step 3. Re-type your new system password to confirm and press [ENTER].
The screen displays an asterisk “
*
” for each character you type.
2.8 Resetting the Prestige
If you forget your password or cannot access the SMT menu, you need to reinstall the configuration file.
Reinstallation replaces the current file with the factory configuration file. All custom configurations will be
lost and the console port speed will be reset to the default. (9600 bps with 8 data bit, no parity, 1 stop bit
(8n1), and no Flow Control.) The password will be reset to the default of 1234.
Turn off your Prestige and begin a Terminal session with the current console port settings. Turn on your
Prestige again. You should see the following screen. When you see the message "Press any key to enter
debug mode within 3 seconds", press any key. Make sure you have the configuration file or have already
downloaded the latest one from the ZyXEL web site.
Figure 2-8 Booting Up the Prestige
To upload the configuration file, do the following:
Step 1. Type atlc after the Enter Debug Mode message.
Step 2. Wait for the Starting XMODEM upload message before activating XMODEM upload on your
terminal.
Step 3. After a successful firmware upload, type atgo to restart the Prestige.
The Prestige is now reinitialized with a default configuration file including the default password of 1234.
Bootbase Version: V2.00 | 4/14/2000 13:58:03
RAM: Size = 8192 Kbytes
DRAM POST: Testing: 8192K OK
FLASH: Intel 8M *2
ZyNOS Version: V2.50(BH.0)b5 | 12/12/2000 14:01:55
Press any key to enter debug mode within 3 seconds.
........................................
(Compressed)
Version: P782R STU, start: 0203c030
Length: 149AAO, Checksum: EEB7
Compressed Length: B4140, Checksum: A562