Filter
Top Products
Prestige 782R G.SHDSL Router
Bridging Setup 7-3
Table 7-2 Remote Node Bridge Options
FIELD DESCRIPTION
Bridge (Menu 11.1) Make sure this field is set to Yes.
Edit IP/IPX/Bridge
(Menu 11.1)
Press [SPACE BAR] to change it to Yes and press [ENTER] to display the
Remote Node Network Layer Options menu.
Ethernet Addr
Timeout
(min.) (Menu 11.3)
Type the time (in minutes) for the Prestige to retain the Ethernet Address
information in its internal tables while the line is down. If this information is
retained, your Prestige will not have to recompile the tables when the line
comes back up.
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC]
to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
7.2.2 Bridge Static Route Setup
Similar to network layer static routes, a bridging static route tells the Prestige the route to a node before a
connection is established. You configure bridge static routes in Menu 12.3.1 (go to Menu 12, choose option
3, then choose a static route to edit) as shown next.
Figure 7-3 Menu 12.3.1 – Edit Bridge Static Route
Menu 12.3.1 - Edit Bridge Static Route
Route #: 1
Route Name=
Active= No
Ether Address= ?
IP Address=
Gateway Node= 1
Press ENTER to Confirm or ESC to Cancel: