Filter
Top Products
Prestige 782R G.SHDSL Router
Filter Configuration 8-7
Figure 8-6 Menu 21.1.1 – TCP/IP Filter Rule
The following table describes how to configure your TCP/IP filter rule.
Table 8-3 TCP/IP Filter Rule Menu Fields
FIELD DESCRIPTION OPTIONS
Filter # This is the filter set, filter rule coordinates, i.e., 2, 3 refers
to the second filter set and the third filter rule of that set.
Filter Type Use [SPACE BAR] to toggle between types of rules.
Parameters displayed for each type will be different.
TCP/IP Filter Rule/
Generic Filter Rule/
IPX Filter Rule
Active
This field activates/deactivates the filter rule. Yes/No
IP Protocol This is the upper layer protocol, e.g., TCP is 6, UDP is 17
and ICMP is 1. The value must be between 0 and 255.
0 to 255
IP Source Route
If Yes, the rule applies to packet with IP source route
option; or else the packet must not have the source route
option. The majority of IP packets do not have source
route.
Yes/No
Destination:
IP Addr
Type the destination IP address of the packet you want to
filter. This field is ignored if it is 0.0.0.0.
IP address
IP Mask Type the IP mask to apply to the Destination: IP Addr IP mask
Menu 21.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 6 IP Source Route= No
Destination: IP Addr= 0.0.0.0
IP Mask= 0.0.0.0
Port #= 137
Port # Comp= Equal
Source: IP Addr= 0.0.0.0
IP Mask= 0.0.0.0
Port #= 0
Port # Comp= None
TCP Estab= No
More= No Log= None
Action Matched= Drop
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.