Filter
Top Products
Prestige 782R G.SHDSL Router
Hardware Installation and Initial Setup 2-11
2.10.4 Standard Mode
If your Prestige is a server, then select the mode that applies to your region: ANSI (American National
Standards Institute) and ETSI (European Telecommunications Standards Institute). If your Prestige is a
client, select the same Standard Mode that the server side selects. ANSI and ETSI create recommendations
and standards for the telecommunications industry.
Figure 2-10 Menu 2 – WAN Setup
Table 2-5 Menu 2 – WAN Setup
FIELD DESCRIPTION
Service Type
Press [SPACE BAR] to select Server (COE) or Client (CPE).
Rate Adaption
Press [SPACE BAR] to select Enable (activate) or Disable (deactivate).
Transfer Max Rate
(2320 Kbps)
Press [SPACE BAR] to select a Transfer Max Rate greater than or equal to
the Transfer Min Rate and press [ENTER] to continue.
Transfer Min Rate
(144 Kbps)
Press [SPACE BAR] to select a Transfer Min Rate less than or equal to the
Transfer Max Rate and press [ENTER] to continue.
Standard Mode
Press [SPACE BAR] to select ANSI (ANNEX A) or ETSI (ANNEX B) and press
[ENTER] to continue. The Client side must match the Server side.
2.11 Ethernet Setup
In the Main Menu, type 3 to open Menu 3 – Ethernet Setup to configure the Ethernet.
Menu 2 - WAN Setup
Service Type: Client
Rate Adaption= Enable
Transfer Max Rate(Kbps)= 2320K
Transfer Min Rate(Kbps)= 144K
Standard Mode= ANSI (ANNEX_A)
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.