Filter
Top Products
Prestige 782R G.SHDSL Router
11-2 IP Routing Policy Setup
IPPR follows the existing packet filtering facility of ZyNOS in style and in implementation. The policies
are divided into sets, where related policies are grouped together. A user defines the policies before
applying them to an interface or a remote node, in the same fashion as the filters. There are 12 policy sets
with 6 policies in each set.
11.4 IP Routing Policy Setup
Menu 25 shows all the policies defined.
Figure 11-1 IP Routing Policy Setup
To setup a routing policy, perform the following procedures:
Step 1. Type 25 in the main menu to open Menu 25 – IP Routing Policy Setup.
Step 2. Type the index of the policy set you want to configure to open Menu 25.1 – IP Routing Policy
Setup.
Menu 25.1 shows the summary of a policy set, including the criteria and the action of a single policy, and
whether a policy is active or not. Each policy contains two lines. The former part is the criteria of the
incoming packet and the latter is the action. Between these two parts, separator “|” means the action is taken
on criteria matched and separator “=” means the action is taken on criteria not matched.
Menu 25 - IP Routing Policy Setup
Policy Policy
Set # Name Set # Name
------ ----------------- ------ -----------------
1 test 7 _______________
2 _______________ 8 _______________
3 _______________ 9 _______________
4 _______________ 10 _______________
5 _______________ 11 _______________
6 _______________ 12 _______________
Enter Policy Set Number to Configure= 0
Edit Name= N/A
Press ENTER to Confirm or ESC to Cancel: