ZyXEL Communications 782R Network Router User Manual


 
Prestige 782R G.SHDSL Router
10-14 System Maintenance
Figure 10-17 Menu 24.7.2 – System Maintenance – Upload Router Configuration File
10.7.3 TFTP Transfer
In addition to the direct console port connection, the Prestige supports the up/downloading of the firmware
and the configuration file using TFTP (Trivial File Transfer Protocol) over LAN. Even though TFTP should
work over WAN as well, it is not recommended.
To use TFTP, your computer must have both telnet and TFTP clients. To transfer the firmware and the
configuration file, follow the next procedures:
Step 1.
Use telnet from your computer to connect to the Prestige and log in. Because TFTP does
not have any security check, the Prestige records the IP address of the telnet client and
accepts TFTP requests only from this address.
Step 2.
Place the SMT in command interpreter (CI) mode by typing 8 in Menu 24 – System
Maintenance.
Step 3.
Type command sys stdio 0 to disable SMT timeout, so the TFTP transfer will not be
interrupted.
Step 4.
Launch TFTP client on your computer and connect to the Prestige. Set the transfer mode
to binary before starting data transfer.
Menu 24.7.2 - System Maintenance - Upload System Configuration File
To upload system configuration file:
1. Enter "y" at the prompt below to go into debug mode.
2. Enter "atlc" after "Enter Debug Mode" message.
3. Wait for "Starting XMODEM upload" message before activating
XMODEM upload on your terminal.
4. After successful firmware upload, type "atgo" to restart the
system.
Warning:
1. Proceeding with the upload will erase the current
configuration file.
2. The system’s console port speed (Menu 24.2.2) may change
when it is restarted; please adjust your terminal's speed
accordingly. The password may change (Menu 23), also.
3. When uploading the DEFAULT configuration file, the console
port speed will be reset to 9600 bps and the password to
"1234".
Do You Wish To Proceed? (Y/N)