Filter
Top Products
Prestige 782R G.SHDSL Router
Remote Node Configuration 4-7
The next table explains TCP/IP-related fields in Menu 11.3
–
Remote Node Network Layer Options.
Table 4-4 Remote Node TCP/IP Configuration
FIELD DESCRIPTION OPTIONS
Rem IP Addr This is the IP address you entered in the previous menu.
Rem Subnet
Mask
Type the subnet mask assigned to the remote node.
My WAN Addr Some implementations, especially UNIX derivatives, require separate
IP network numbers for the WAN and LAN links and each end to have a
unique address within the WAN network number. In that case, type the
IP address assigned to the WAN port of your Prestige.
NOTE: This is your local Prestige address, not the remote router’s.
Single User
Account
Use [SPACE BAR] to toggle between Yes and No. Yes enables the
Single User Account feature of your Prestige.
Yes/No
Metric The metric represents the “cost” of transmission for routing purposes.
IP routing uses hop count as the cost measurement, with a minimum of
1 for directly connected networks. Type a number that approximates the
cost for this link. The number need not be precise, but it must be
between 1 and 15. In practice, 2 or 3 is usually a good number.
1 to 15
Private This determines if the Prestige will include the route to this remote node
in its RIP broadcasts. If set to Yes, this route is kept private and not
included in RIP broadcast. If No, the route to this remote node will be
propagated to other hosts through RIP broadcasts.
Yes/No
RIP Direction
Press [SPACE BAR] to select the RIP Direction from Both/In Only/Out
Only and None.
Both/None/
In Only/ Out
Only
Version
Press [SPACE BAR] to select the RIP version from RIP-1/RIP-2B/RIP-
2M.
RIP-1 /
RIP-2B / RIP-
2M
Multicast Sets IGMP to version 1, version 2, or disables IGMP.
IGMP-v1/
IGMP-v2/
None
IP Policies You can apply up to four IP Policy sets (from twelve) by typing in their
numbers separated by commas.
3, 4, 5, 6
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC] to
cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.