Filter
Top Products
Prestige 782R G.SHDSL Router
3-14 Internet Access
The following table contains instructions on how to configure your Prestige for Internet access.
Table 3-5 Internet Access Setup Menu Fields
FIELD DESCRIPTION
ISP’s Name Type the name of your ISP, e.g., myISP. This field is for identification
purposes only.
Encapsulation Press [SPACE BAR] to select the method of encapsulation. Options
include: PPP (RFC-2364 for PPP over ATM), RFC-1483 (Multi-protocol
over ATM), or ENET ENCAP. If you select ENET ENCAP then the
Single User Account field is Yes (enabled) by default.
Multiplexing
Press [SPACE BAR] to select VC-based or LLC-based multiplexing.
VPI # Type the Virtual Path Identifier (VPI) given by the telephone company.
VCI # Type the Virtual Channel Identifier (VCI) given by the telephone company.
Peak Cell Rate (cell/sec)
Default = 5500 cell/sec
This is the maximum rate at which the sender plans to send cells during
the connection’s lifetime.
NOTE: A 2.3 Mbps line rate will result in a PCR of 5424 cell/sec by setting
the Sustained Cell Rate field and Maximum Burst Size field at 0.
Sustained Cell Rate
(cell/sec)
Default = 0 cell/sec
Sustained Cell Rate, (always smaller than the PCR), is the mean cell rate
of a bursty, on-off traffic source that can be sent at the peak rate, and a
parameter for burst-type traffic.
Type the SCR, which must be less than the PCR.
Maximum Burst Size (cell) Refers to the maximum number of cells that can be sent at the peak rate.
Type the MBS, which is less than 65535.
My Login Type the login name given to you by your ISP.
My Password
Type the password associated with the My Login field above.
Single User Account
Press [SPACE BAR] to enable or disable SUA. Please refer to the section
ahead for more details on the Single User Account feature.
IP Address Assignment
Press [SPACE BAR] to select Static or Dynamic address assignment.
IP Address If your ISP did not assign you a static IP address, type 0.0.0.0; otherwise,
type that IP address here. Please refer to the section ahead for more
details on setting the IP address under a Single User Account.
ENET ENCAP Gateway
This field is N/A unless you choose ENET ENCAP in the Encapsulation
field. Type the gateway IP address supplied by your ISP when applicable.