Filter
Top Products
Prestige 782R G.SHDSL Router
IPX Configuration 6-7
From Menu 12, type 2, then select one of the IPX Static Routes to open Menu 12.2.1 – Edit IPX Static
Route, as shown next.
Figure 6-6 Menu 12.2.1 – Edit IPX Static Route
The following table contains the instructions on how to configure the Edit IPX Static Route menu.
Table 6-3 Edit IPX Static Route Menu Fields
FIELD DESCRIPTION
Route #
This is the route index number as listed in Menu 12.2 – IPX Static Route Setup.
Server Name
Type the server name. This must be the
exact
name configured in the NetWare server.
Active
This allows you to activate/deactivate this static route.
Network # This is the internal network number of the remote server you want to access.
[00000000] and [FFFFFFFF] are reserved.
Node # This is the address of the node on which the server resides. For a Novell IPX
implementation, the value is [000000000001].
Socket #
The server will receive service requests on this socket. The default is hex [0451].
Type #
This identifies the type of service the server provides. The default is hex [0004].
Hop Count This is the number of intermediate networks that must be passed through to reach the
remote node.
Tick Count This indicates the time-ticks required to reach the remote node.
Gateway Node Type the remote node number that is the gateway for this static route.
When you have completed this menu, press [ENTER] at the prompt “Press [ENTER] to confirm or [ESC]
to cancel” to save your configuration or press [ESC] to cancel and go back to the previous screen.
Menu 12.2.1 - Edit IPX Static Route
Route #= 1
Server Name= ?
Active= Yes
Network #= ?
Node #= 000000000001
Socket #= 0451
Type #= 0004
Hop Count= 2
Tick Count= 3
Gateway Node= 1
Press ENTER to Confirm or ESC to Cancel: