Filter
Top Products
Prestige 782R G.SHDSL Router
4-8 Remote Node Configuration
4.3 Remote Node Filter
Move the cursor to the field Edit Filter Sets in Menu 11.1, then press [SPACE BAR] to toggle and set the
value to Yes. Press [ENTER] to display Menu 11.5 – Remote Node Filter.
Use Menu 11.5 – Remote Node Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between this remote node and the Prestige and also to prevent certain packets from triggering calls.
You can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field. The Prestige has a prepackaged filter set, NetBIOS_WAN, that
blocks NetBIOS packets (call protocol filter = 1). Include this in the call filter sets if you want to prevent
NetBIOS packets from triggering calls to a remote node.
Figure 4-5 Menu 11.5 – Remote Node Filter
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Enter here to CONFIRM or ESC to CANCEL: