Filter
Top Products
1-4
To do... Use the command... Remarks
Limit unknown unicast traffic
received on the current port
unicast-suppression { ratio |
pps max-pps }
Optional
By default, the switch does not
suppress unknown unicast
traffic.
Enabling Flow Control on a Port
Flow control is enabled on both the local and peer switches. If congestion occurs on the local switch:
z The local switch sends a message to notify the peer switch of stopping sending packets to itself or
reducing the sending rate temporarily.
z The peer switch will stop sending packets to the local switch or reduce the sending rate temporarily
when it receives the message; and vice versa. By this way, packet loss is avoided and the network
service operates normally.
Follow these steps to enable flow control on a port:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Enable flow control on the
Ethernet port
flow-control
By default, flow control is not
enabled on the port.
Duplicating the Configuration of a Port to Other Ports
To make other ports have the same configuration as that of a specific port, you can duplicate the
configuration of a port to specific ports.
Specifically, the following types of port configuration can be duplicated from one port to other ports:
VLAN configuration, LACP configuration, QoS configuration, STP configuration and initial port
configuration. Refer to the command manual for the configurations that can be duplicated.
Follow these steps to duplicate the configuration of a port to specific ports:
To do... Use the command... Remarks
Enter system view
system-view
—
Duplicate the
configuration of a port to
specific ports
copy configuration source { interface-type
interface-number | aggregation-group
source-agg-id } destination { interface-list
[ aggregation-group destination-agg-id ] |
aggregation-group destination-agg-id }
Required