Filter
Top Products
2-4
Configuration Remarks
Set the maximum
number of lines the
screen can contain
Optional
By default, the screen can contain up to 24 lines.
Set history
command buffer
size
Optional
By default, the history command buffer can contain up
to 10 commands.
Set the timeout time
of a user interface
Optional
The default timeout time is 10 minutes.
The change to console port configuration takes effect immediately, so the connection may be
disconnected when you log in through a console port and then configure this console port. To configure
a console port, you are recommended to log in to the switch in other ways. To log in to a switch through
its console port after you modify the console port settings, you need to modify the corresponding
settings of the terminal emulation utility running on your PC accordingly in the dialog box shown in
Figure 2-4.
Follow these steps to set common configuration of console port login:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter AUX user interface view user-interface aux 0 —
Set the baud
rate
speed speed-value
Optional
The default baud rate of a console
port is 19,200 bps.
Set the check
mode
parity { even | none |
odd }
Optional
By default, the check mode of a
console port is none, that is, no
check is performed.
Set the stop bits stopbits { 1 | 1.5 | 2 }
Optional
The stop bits of a console port is 1.
Configure
the console
port
Set the databits databits { 7 | 8 }
Optional
The default databits of a console port
is 8.
Configure the command level
available to users logging in to
the user interface
user privilege level level
Optional
By default, commands of level 3 are
available to users logging in to the
AUX user interface, and commands
of level 0 are available to users
logging in to the VTY user interface.
Enable terminal services
shell
Optional
By default, terminal services are
available in all user interfaces.