Filter
Top Products
1-2
This parameter is used to enable the system to automatically perform the same test at regular intervals.
5) Test timeout time
Test timeout time is the duration while the system waits for an ECHO-RESPONSE packet after it sends
out an ECHO-REQUEST packet. If no ECHO-RESPONSE packet is received within this duration, this
test is considered a failure. This parameter is similar to the -t keyword in the ping command, but has a
different unit (the -t keyword in the ping command is in milliseconds, while the timeout time in the
remote-ping command is in seconds).
Configuring remote-ping
Table 1-1 Configure remote-ping
Operation Command Description
Enter system view
system-view
—
Enable remote-ping Client
remote-ping-agent enable
Required
By default, remote-ping Client
is disabled.
Create an remote-ping test
group
remote-ping
administrator-name operation-
tag
Required
By default, no remote-ping test
group is configured.
Configure the destination IP
address of the test
destination-ip ip-address
Required
By default, no destination IP
address is configured.
Configure the test type
test-type type
Optional
By default, the test type is
ICMP.
Configure the number of
packets to be sent in each test.
count times
Optional
By default, the number of
packets to be sent in each test
is 1.
Configure the automatic test
interval.
frequency interval
Optional
By default, the automatic test
interval is zero, indicating no
automatic test will be
performed.
Configure the timeout time of
the test.
timeout time
Optional
By default, the timeout time is 3
seconds.
Execute the test
test-enable
Required
Displaying remote-ping Configuration
After the above remote-ping configuration, you can execute the display command in any view to
display the information of remote-ping test operation status to you can verify the configuration effect.