Filter
Top Products
1-14
z The cluster switches are properly connected;
z The shared servers are properly connected to the management switch.
2) Configuration procedure
Follow these steps to configure the network management interface for a cluster:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
Required
Configure the network
management (NM) interface for
the cluster
nm-interface Vlan-interface
vlan-id
Required
By default, the management
VLAN interface is used as the
NM interface.
Enabling management VLAN synchronization
By default, VLAN 1 is the management VLAN. To specify another VLAN as the management VLAN for
the cluster, you must configure the same management VLAN on all the devices that are about to join the
cluster.
By enabling the management VLAN synchronization function on the management device, you can
enable the management device to send a management VLAN synchronization packet periodically to
the connected devices. After the devices receive the management VLAN synchronization packet, they
set their own management VLANs according to the packet. In this way, all devices set the same
management VLAN automatically, and thus simplify your configurations.
Follow these steps to enable management VLAN synchronization:
To do… Use the command… Remarks
Enter system view
system-view
—
Enter cluster view
cluster
Required
Enable management VLAN
synchronization
management-vlan
synchronization enable
Required
Disabled by default.
Configuring Member Devices
Member device configuration task list
Complete the following tasks to configure the member device:
Task Remarks
Enabling NDP globally and on specific ports Required
Enabling NTDP globally and on a specific port Required
Enabling the cluster function Required
Accessing the shared FTP/TFTP server from a
member device
Optional