Filter
Top Products
1-13
To do… Use the command… Remarks
Enable information
output to the log buffer
info-center logbuffer [ channel
{ channel-number |
channel-name } | size buffersize ]*
Optional
By default, the switch uses
information channel 4 to output log
information to the log buffer, which
can holds up to 512 items by
default.
Configure the output
rules of system
information
info-center source { modu-name |
default } channel
{ channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to
Table 1-4 for the default
output rules of system information.
Set the format of time
stamp in the output
information
info-center timestamp { log | trap
| debugging } { boot | date |
none }
Optional
By default, the time stamp format
of the output log information is
date.
Setting to Output System Information to the SNMP NMS
Follow these steps to set to output system information to the SNMP NMS:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the information
center
info-center enable
Optional
Enabled by default.
Enable information
output to the SNMP NMS
info-center snmp channel
{ channel-number |
channel-name }
Optional
By default, the switch outputs trap
information to SNMP through
channel 5.
Configure the output
rules of system
information
info-center source { modu-name |
default } channel
{ channel-number |
channel-name } [ { log | trap |
debug } { level severity | state
state } ]*
Optional
Refer to
Table 1-4 for the default
output rules of system information.
Set the format of time
stamp in the output
information
info-center timestamp { log | trap
| debugging } { boot | date |
none }
Optional
By default, the time stamp format
of the information output to the
SNMP NMS is date.
To send information to a remote SNMP NMS properly, related configurations are required on both the
switch and the SNMP NMS. For the detailed configuration, refer to the SNMP-RMON part.