Filter
Top Products
3-10
Configuring RIP to unicast RIP packets
Follow these steps to configure RIP to unicast RIP packets:
To do... Use the command... Remarks
Enter system view
system-view
—
Enter RIP view
rip
—
Configure RIP to
unicast RIP packets
peer ip-address
Required
When RIP runs on the link that does not support
broadcast or multicast, you must configure RIP to
unicast RIP packets.
Displaying and Maintaining RIP Configuration
To do... Use the command... Remarks
Display the current RIP running status and
configuration information
display rip
Display RIP interface information
display rip interface
Display RIP routing information
display rip routing
Available in any
view
Reset the system configuration related to RIP
reset
Available in RIP
view
RIP Configuration Example
Network requirements
A small-sized company requires that any two nodes in its small office network communicate with each
other, and that the network devices automatically adapt themselves to any topology change so as to
reduce the work of manual maintenance.
In this case, RIP can implement communication between any two nodes.
Network diagram
According to the network requirements, the network topology is designed as shown in Figure 3-1.
Figure 3-1 Network diagram for RIP configuration
Device Interface IP address Device Interface IP address
Switch A Vlan-int1 110.11.2.1/24 Switch B Vlan-int1 110.11.2.2/24
Vlan-int2 155.10.1.1/24 Vlan-int3 196.38.165.1/24