Filter
Top Products
1-29
To do... Use the command... Remarks
Enter system view
system-view
—
Enable MSTP
stp enable
Required
MSTP is enabled globally by default.
Enter Ethernet port view
interface interface-type
interface-number
—
Disable MSTP on the
port
stp disable
Optional
By default, MSTP is enabled on all ports.
To enable a switch to operate more
flexibly, you can disable MSTP on
specific ports. As MSTP-disabled ports
do not participate in spanning tree
calculation, this operation saves CPU
resources of the switch.
Other MSTP-related settings can take effect only after MSTP is enabled on the switch.
Configuration example
# Disable MSTP on Ethernet 1/0/1.
1) Perform this configuration in system view
<Sysname> system-view
[Sysname] stp interface Ethernet 1/0/1 disable
2) Perform this configuration in Ethernet port view
<Sysname> system-view
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] stp disable
Configuring Leaf Nodes
Configuring the MST Region
Refer to Configuring an MST Region.
Configuring How a Port Recognizes and Sends MSTP Packets
Refer to Configuring How a Port Recognizes and Sends MSTP Packets.
Configuring the Timeout Time Factor
Refer to Configuring the Timeout Time Factor.
Configuring the Maximum Transmitting Rate on the Current Port
Refer to Configuring the Maximum Transmitting Rate on the Current Port.
Configuring a Port as an Edge Port
Refer to Configuring the Current Port as an Edge Port.