Filter
Top Products
Command Reference Guide Port Channel Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1032
switchport mode [access | trunk]
Use the switchport mode command to configure the VLAN membership mode. To reset membership
mode to the default value, use the no version of this command.
Syntax Description
access Sets port to be a single (non-trunked) port that transmits and receives no tagged
packets.
trunk Sets port to transmit and receive packets on all VLANs included within its VLAN
allowed list.
Default Values
By default, this is set to access.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example sets the port to be a trunk port:
(config)#interface port-channel 1
(config-p-chan 1)#switchport mode trunk