Filter
Top Products
Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 476
mac address-table static <mac address> vlan <vlan id> interface
<interface>
Use the mac address-table static command to insert a static MAC address entry into the MAC address
table. Use the no form of this command to remove an entry from the table.
Syntax Description
<mac address> Specifies a valid 48-bit MAC address.
<vlan id> Specifies a valid VLAN interface ID (1 to 4094).
interface Specifies the interface. Type mac address-table static vlan interface ? for a
complete list of valid interfaces.
<interface> Specifies a valid slot/port interface ID (e.g., eth 0/1).
Default Values
By default, there are no static entries configured.
Applicable Platforms
This command applies to the NetVanta 300, 1000, and 1000R Series units.
Command History
Release 5.1 Command was introduced.
Usage Examples
The following example adds a static MAC address to Ethernet 0/1 on VLAN 4:
(config)#mac address-table static 00:A0:C8:00:00:01
00:12:79:00:00:01
vlan 4 interface ethernet 0/1