Filter
Top Products
Command Reference Guide Global Configuration Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 371
crypto ike remote-id
Use the crypto ike remote-id command to specify the remote ID and to associate a pre-shared key with
the remote ID.
Syntax Description
address
<IPv4 address>
Specifies a remote ID of IPv4 type.
any Wildcard that allows any remote ID (type and value).
asn1-dn
<name>
Specifies an abstract syntax notation distinguished name as
the remote ID (enter this value in LDAP format).
fqdn
<fqdn>
Specifies a fully qualified domain name (e.g., adtran.com) as
the remote ID.
user-fqdn
<fqdn>
Specifies a user fully qualified domain name or email address
(e.g., user1@adtran.com) as the remote ID.
preshared-key
<keyname>
Associates a preshared key with this remote ID.
no-mode-config Optional. keyword used to specify that the peer matching this
remote ID should not use mode config.
no-xauth Optional. Keyword used to specify that the peer matching this
remote ID should not use xauth.
nat-t [v1 l v2] [allow l force I disable] Optional. Keyword that denotes whether peers matching this
remote ID should allow, disable, or force NAT traversal
versions 1 and 2.
Default Values
There are no default settings for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1 Command was introduced.
Release 5.1 Command was expanded to include the any, asn1-dn, and no-xauth
subcommands.
Release 7.1 Command was expanded to include NAT traversal commands.
For VPN configuration example scripts, refer to the technical support note VPN
Configuration Guide located on the ADTRAN OS Documentation CD provided with
your unit.