Filter
Top Products
Command Reference Guide Demand Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 782
DEMAND INTERFACE CONFIGURATION COMMAND SET
To activate the Demand Interface Configuration mode, enter the interface demand command at the
Global Configuration mode prompt. For example:
#
configure terminal
(config)#
interface demand 1
(config-demand 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
access-policy <policyname> on page 784
bandwidth <value> on page 787
called-number <DNIS number> on page 788
caller-number <CLID number> on page 789
connect-mode [answer | originate | either] on page 790
connect-order [last-successful | round-robin | sequential] on page 791
connect-sequence on page 792
connect-sequence attempts <value> on page 794
connect-sequence interface-recovery [retry-interval <seconds> | max-retries <value>] on
page 795
crypto map <mapname> on page 796
demand-hold-queue <packets> timeout <seconds> on page 798
dynamic-dns [dyndns | dyndns-custom | dyndns-static] <hostname> <username>
<password> on page 799