Filter
Top Products
Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 187
show frame-relay
Use the show frame-relay command to display configuration and status parameters for configured virtual
Frame Relay interfaces.
Variations of this command include the following:
show frame-relay lmi
show frame-relay pvc
show frame-relay pvc interface frame-relay <interface>
show frame-relay pvc realtime
Syntax Description
lmi Displays Link Management Interface (LMI) statistics for each virtual Frame Relay
interface.
pvc Displays Permanent Virtual Circuit (PVC) configuration and statistics for all virtual
Frame Relay interfaces (or a specified interface).
frame-relay Optional. Displays Frame Relay PVC statistics for a specific Frame Relay
interface.
<interface> Specifies the virtual Frame Relay interface (for example fr 1).
realtime Displays full-screen output in realtime. See the Functional Notes below for more
information.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Release 10.1 Realtime option was introduced.
Functional Notes
Use the realtime argument for this command to display full-screen output in real time. Information is
continuously updated on the console until you either freeze the data (by pressing the F key) or exit
realtime mode (by pressing Ctrl-C). If there is not enough room on the screen for all available data, the
information will truncate at the bottom of the screen. In order to maximize the amount of data displayed,
increase the terminal length (using the terminal length command; refer to
terminal length <text> on page
318
).