Filter
Top Products
Command Reference Guide G.703 Interface Configuration Command set
61200510L1-35E Copyright © 2005 ADTRAN 664
G.703 INTERFACE CONFIGURATION COMMAND SET
To activate the G.703 Interface Configuration mode, enter the interface e1 command (and specify the
G.703 port) at the Global Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface e1 1/2
(config-e1 1/2)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
coding [ami | hdb3] on page 665
framing [crc4] on page 666
loopback network [line | payload] on page 667
snmp trap link-status on page 668
test-pattern [ones | zeros] on page 669
ts16 on page 670