Filter
Top Products
Command Reference Guide Crypto Map Manual Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1249
set transform-set <setname>
Use the set transform-set command to assign a transform set to a crypto map. See crypto ipsec
transform-set <setname> <parameters> on page 374 for information on defining transform sets.
Syntax Description
<setname> Assigns a transform set to this crypto map by entering the set name.
Default Values
By default, no transform set is assigned to the crypto map.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 Series units.
Command History
Release 4.1 Command was introduced.
Functional Notes
Crypto map entries do not directly contain the transform configuration for securing data. Instead, the crypto
map is associated with transform sets which contain specific security algorithms (see
crypto ipsec
transform-set <setname> <parameters> on page 374
).
If no transform set is configured for a crypto map, then the entry is incomplete and will have no effect on
the system. For manual key crypto maps, only one transform set can be specified.
Usage Examples
The following example first creates a transform set (Set1) consisting of two security algorithms (up to three
may be defined), and then assigns the transform set to a crypto map (Map1):
(config)#crypto ipsec transform-set Set1 esp-3des esp-sha-hmac
(cfg-crypto-trans)#exit
(config)#crypto map Map1 1 ipsec-manual
(config-crypto-map)#set transform-set Set1