Filter
Top Products
Command Reference Guide Frame Relay Interface Config Command Set
61200510L1-35E Copyright © 2005 ADTRAN 845
encapsulation frame-relay ietf
Use the encapsulation frame-relay ietf command to configure the encapsulation on a virtual Frame Relay
interface as IETF (RFC1490). Currently, this is the only encapsulation setting. Settings for this option must
match the far-end router’s settings in order for the Frame Relay interface to become active.
Syntax Description
No subcommands.
Default Values
By default, all Frame Relay interfaces use IETF encapsulation.
Applicable Platforms
This command applies to the NetVanta 1000R, 3000, 4000, and 5000 and Total Access 900 Series units.
Command History
Release 1.1 Command was introduced.
Usage Examples
The following example configures the endpoint for IETF encapsulation:
(config)#interface frame-relay 1
(config-fr 1)#encapsulation frame-relay ietf