Filter
Top Products
Command Reference Guide IKE Policy Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1272
respond [main | aggressive | anymode]
Use the respond command to allow the IKE policy to respond to negotiations by a peer. Use the no form
of this command to allow the policy to only initiate negotiations.
Syntax Description
main Specifies to respond only to main mode.
aggressive Specifies to respond only to aggressive mode.
anymode Specifies to respond to any mode.
Default Values
By default, respond to any mode is enabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 4.1 Command was introduced.
Functional Notes
By using the initiate and respond commands, you can configure the IKE policy to initiate and respond,
initiate only, or respond only. It is an error if you have both initiate and respond disabled.
Usage Examples
The following example configures the router to initiate and respond to IKE negotiations:
(config-ike)#respond anymode
(config-ike)#initiate main