Filter
Top Products
Command Reference Guide Router (OSPF) Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 1312
redistribute static [metric <value> | metric-type <type> | subnets]
Use the redistribute static command to advertise routes from one protocol to another. Using the static
keyword allows the advertisement of static routes into the OSPF routing protocol. This will advertise all
static routes on OSPF-enabled interfaces. It does not enable OSPF on all interfaces. Use the no form of this
command to disable the propagation of the specified route type.
Syntax Description
metric <value> Optional. Specifies a metric value to be carried from one OSPF process to the
next (if no other value is specified).
metric-type <type> Optional. Specifies a type 1 or type 2 external route as the external link type. If not
specified, the default is 2.
subnets Optional. Specifies subnet redistribution when redistributing routes into OSPF.
Default Values
By default, this command is disabled.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000, and 5000 and Total Access 900
Series units.
Command History
Release 1.1 Command was introduced.
Release 10.1 Subcommands were added.
Functional Notes
Redistributing static routes imports those routes into OSPF without the interfaces in question actually
participating in OSPF. The static routes imported this way are not covered by a network command and
therefore do not send/receive OSPF traffic.
Usage Examples
The following example imports static routes into OSPF:
(config)#router ospf
(config-ospf)#redistribute static