Filter
Top Products
Command Reference Guide Enable Mode Command Set
61200510L1-35E Copyright © 2005 ADTRAN 238
show ip protocols
Use the show ip protocols command to display IP routing protocol parameters and statistics.
Syntax Description
No subcommands.
Default Values
No default value necessary for this command.
Applicable Platforms
This command applies to the NetVanta 300, 1000R, 2000, 3000, 4000,
and 5000
and Total Access 900
Series
units.
Command History
Release 3.1 Command was introduced.
Usage Examples
The following is a sample output from the
show ip protocols
command:
>enable
#
show ip protocols
Sending updates every 30 seconds, next due in 8 seconds
Invalid after 180 seconds, hold down time is 120 seconds
Redistributing: rip
Default version control: send version 2, receive version 2
Interface Send Ver. Rec Ver.
eth 0/1 2 2
ppp 1 2 2
Routing for networks:
1.1.1.0/24