Filter
Top Products
Command Reference Guide E1 Interface Configuration Command Set
61200510L1-35E Copyright © 2005 ADTRAN 596
E1 INTERFACE CONFIGURATION COMMAND SET
To activate the E1 Interface Configuration mode, enter the interface e1 command (and specify the E1
port) at the Global Configuration mode prompt. For example:
>enable
#
configure terminal
(config)#
interface e1 1/1
(config-e1 1/1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
alias <“text”> on page 27
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
description <text> on page 31
do on page 32
end on page 33
exit on page 34
shutdown on page 35
All other commands for this command set are described in this section in alphabetical order.
clock source [internal | line | through] on page 597
coding [ami | hdb3] on page 598
framing [crc4] on page 599
loop-alarm-detect on page 600
loopback network [line | payload] on page 601
loopback remote v54 on page 602
remote-alarm [rai | ais] on page 603
remote-loopback on page 604
sa4tx-bit [0 | 1] on page 605
show test-pattern on page 606
snmp trap line-status on page 607
snmp trap link-status on page 608
snmp trap threshold-reached on page 609
tdm-group <group number> timeslots <1-31> speed [56 | 64] on page 610
test-pattern [clear | insert | ones| p215 | p220 | p511 | qrss | zeros] on page 611
ts16 on page 612